Skip to content

Colloids and Surfaces Formula Sheet and Short Notes

One-page CSIR NET revision: colloids, micelles, Stokes–Einstein, double layer, DLVO, Schulze–Hardy, Langmuir, BET, Gibbs adsorption and heterogeneous catalysis.

  • 7 min read
  • Updated
On this page · 8 sections
  1. Colloids: Types and Micelles
  2. Kinetic and Optical Properties
  3. Charge, Double Layer and Electrokinetics
  4. Stability and Coagulation
  5. Adsorption
  6. Heterogeneous Catalysis
  7. Last-Minute Traps
  8. Where Next

The whole unit on one page. For explanations and worked problems, go back to the chapter: Colloids: Classification and Properties, Double Layer and Colloid Stability, Adsorption Isotherms and Surface Area and Heterogeneous Catalysis.

Colloids: Types and Micelles

FactDetail
Size rangeabout 1 nm–1 µm in at least one dimension
Phase typessol, emulsion, foam, solid aerosol, liquid aerosol, gel, solid foam, solid sol; no gas-in-gas
Lyophilicsolvated, reversible, stable, viscous, weak Tyndall; starch, gelatin, proteins
Lyophobiccharge-stabilised only, irreversible, coagulated by a little salt, strong Tyndall; metal sols, As₂S₃, Fe(OH)₃
Condensation methodsdouble decomposition (As₂S₃), hydrolysis (Fe(OH)₃), reduction (Au), oxidation (S)
Dispersion methodsBredig arc (metal sols), peptisation, colloid mill
Purificationdialysis, electrodialysis (electrolytes only), ultrafiltration
CMCbreak in γ, κ (slope falls), Λ, turbidity, dye solubilisation
CMC trendsfalls with longer tail, added salt; non-ionic far lower than ionic
Krafft point / cloud pointno micelles below Krafft T (ionic); non-ionic separates above cloud point
\( \Delta G^\circ_{\text{mic}} \)\( RT\ln x_{\text{CMC}} \) (mole fraction; divide M by 55.5); \( (1+\beta) \) for ionic
Driving forceentropy (hydrophobic effect)
Packing parameter\( v/a_0l_c \): < 1/3 sphere; 1/3–1/2 rod; 1/2–1 bilayer/vesicle; > 1 inverted

Kinetic and Optical Properties

FactDetail
Brownian motion\( \langle x^2\rangle = 2Dt \); \( \langle r^2\rangle = 6Dt \)
Stokes–Einstein\( D = k_BT/(6\pi\eta r) \); DLS gives hydrodynamic radius
Stokes settling\( v = 2r^2(\rho_p-\rho)g/9\eta \) (∝ r²)
Sedimentation coefficient\( s = v/\omega^2r = m(1-\bar v\rho)/f \); 1 S = 10⁻¹³ s
Svedberg\( M = sRT/[D(1-\bar v\rho)] \)
Sedimentation equilibrium\( c_2/c_1 = \exp[M(1-\bar v\rho)\omega^2(r_2^2-r_1^2)/2RT] \)
Perrin\( n_h/n_0 = \exp(-m_{\text{eff}}gh/k_BT) \), \( m_{\text{eff}} = \tfrac43\pi r^3(\rho_p-\rho) \)
Einstein viscosity\( \eta = \eta_0(1+2.5\phi) \)
Molar-mass averagesosmometry \( M_n \); light scattering, sedimentation equilibrium \( M_w \); \( M_w \ge M_n \)
Rayleigh\( I \propto r^6/\lambda^4 \); (650/450)⁴ = 4.35
Debye–Zimm\( Kc/R_\theta = 1/M_w + 2A_2c \)
Ultramicroscopeparticles as points of light; number and motion, not shape
Gold sol colourred (small) → blue (large or aggregated)

Charge, Double Layer and Electrokinetics

FactDetail
Positive solsFe(OH)₃, Al(OH)₃, AgI in excess AgNO₃, basic dyes
Negative solsAs₂S₃, Au, Ag, Pt, clay, starch, AgI in excess KI, acid dyes
ModelsHelmholtz (rigid) → Gouy–Chapman (diffuse) → Stern (compact + diffuse)
Diffuse potential\( \psi = \psi_0e^{-\kappa x} \)
Debye length\( \kappa^{-1} = 0.304/\sqrt{I} \) nm (water, 25 °C); 1 mM 1:1 → 9.6 nm; 0.1 M → 0.96 nm
Ionic strength\( I = \tfrac12\sum c_iz_i^2 \) (0.01 M MgSO₄ → 0.04 M)
Zeta potentialat the plane of shear; IEP where ζ = 0; stable sols typically |ζ| above about 30 mV
Field → motionelectrophoresis (particles), electro-osmosis (liquid)
Motion → potentialstreaming potential (liquid), sedimentation potential (particles)
Smoluchowski\( u = \varepsilon\zeta/\eta \), \( \kappa a \gg 1 \)
Hückel\( u = 2\varepsilon\zeta/3\eta \), \( \kappa a \ll 1 \)

Stability and Coagulation

FactDetail
DLVO\( V_T = V_R + V_A \); \( V_A = -A_Ha/12h \); \( V_R \approx 2\pi\varepsilon a\psi_0^2e^{-\kappa h} \)
Curve featuresprimary minimum (coagulation), barrier (stability), secondary minimum (reversible flocculation)
Saltcompresses double layer, lowers barrier; van der Waals unchanged
Schulze–Hardycounterion coagulates; ccc ∝ z⁻⁶ → 1 : 1/64 : 1/729
Negative solAl³⁺ > Ba²⁺ > Na⁺
Positive sol[Fe(CN)₆]⁴⁻ > PO₄³⁻ > SO₄²⁻ > Cl⁻
Flocculation valuelower value = stronger coagulant
Other coagulationmutual (opposite sols), electrophoresis, prolonged dialysis, heating
Fast coagulation\( k_f = 4k_BT/3\eta \) (6.2 × 10⁻¹⁸ m³ s⁻¹ in water at 298 K); \( t_{1/2} = 1/k_fn_0 \); second order
Gold numbermg protective colloid preventing red → blue of 10 mL gold sol with 1 mL 10% NaCl; smaller = better (gelatin best, starch poor)
Polymerssteric (good solvent) stabilises; bridging, depletion, poor solvent destabilise
EmulsionsBancroft rule; O/W conducts, dilutes with water; low HLB → W/O, high HLB → O/W
Breakdowncreaming, flocculation, coalescence, Ostwald ripening
Gelsthixotropy, syneresis, imbibition

Adsorption

FactDetail
SignΔS < 0, ΔG < 0 → ΔH < 0
Physisorptionabout 20 kJ mol⁻¹; van der Waals; multilayer; non-specific; low T; follows ease of liquefaction
Chemisorptionabout 100–400 kJ mol⁻¹; bonds; monolayer; specific; often activated
Residence time\( \tau = \tau_0e^{E_d/RT} \), \( \tau_0 \sim 10^{-13} \) s
Langmuir\( \theta = KP/(1+KP) \); low P first order, high P zero order; half coverage at P = 1/K
Linear form\( P/V = 1/KV_m + P/V_m \)
Dissociative\( \theta = (KP)^{1/2}/[1+(KP)^{1/2}] \) → \( \propto P^{1/2} \) at low P
Competitive\( \theta_A = K_AP_A/(1+K_AP_A+K_BP_B) \)
Isosteric\( \ln(P_2/P_1) = (\Delta H_{\text{ads}}/R)(1/T_2-1/T_1) \) at constant θ
Freundlich\( x/m = kP^{1/n} \), n > 1; heat falls logarithmically
Temkin\( \theta = c_1\ln(c_2P) \); heat falls linearly
BET\( x/[V(1-x)] = 1/V_mc + (c-1)x/V_mc \); 0.05–0.30; \( V_m = 1/(s+i) \), \( c = 1+s/i \)
Surface area\( S = V_mN_A\sigma/22414 \); N₂ σ = 0.162 nm² → 4.35 m² per cm³ STP
Isotherm typesI micropores; II non-porous; III weak; IV mesopores + hysteresis; V weak + meso; VI steps
Poresmicro < 2 nm; meso 2–50 nm; macro > 50 nm
Laplace\( \Delta P = 2\gamma/r \) (bubble with two surfaces \( 4\gamma/r \))
Capillary rise\( h = 2\gamma\cos\theta/\rho gr \)
Young\( \gamma_{SV} = \gamma_{SL} + \gamma_{LV}\cos\theta \)
Kelvin\( \ln(P/P_0) = 2\gamma V_m/rRT \); capillary condensation below P₀ in pores
Gibbs\( \Gamma = -(1/RT)\,d\gamma/d\ln c \); \( 1/2RT \) for 1:1 ionic surfactant without salt
Area per molecule\( 1/(N_A\Gamma) \)
Collision flux\( Z_W = P/\sqrt{2\pi mk_BT} \)

Heterogeneous Catalysis

FactDetail
Catalystlowers barrier; never changes K or ΔG°
TOFmolecules per site per second; one H₂ titrates two surface atoms
Dispersionsurface metal / total metal
Unimolecular\( r = kK_AP_A/(1+K_AP_A) \); order \( 1-\theta_A \)
Inhibited\( r = kK_AP_A/K_BP_B \) (B dominates surface)
Langmuir–Hinshelwood\( r = kK_AK_BP_AP_B/(1+K_AP_A+K_BP_B)^2 \); max at \( K_AP_A = 1+K_BP_B \) (\( \theta_A = 1/2 \))
Eley–Rideal\( r = kK_AP_AP_B/(1+K_AP_A) \); saturates, no maximum
Apparent Estrong ads: E; weak ads: E − q_A; with inhibitor: E − q_A + q_B
Sabatierintermediate binding best; volcano plot (formic acid decomposition classic)
PromotersK₂O electronic, Al₂O₃ structural (Haber Fe)
PoisonsS, As, Pb, CO; Lindlar = deliberate selective poisoning
Deactivationpoisoning, coking, sintering, leaching
Thiele\( \eta = \tanh\phi/\phi \); large φ: η ≈ 1/φ, \( E_{\text{app}} \approx E/2 \)
Mass-transfer testspellet size → pore diffusion; flow rate → film diffusion
ZeolitesAl for Si → Brønsted H⁺ sites; ZSM-5 para-xylene; zeolite Y in FCC
CatalystsFe (NH₃); Pt–Rh (NH₃ → NO); V₂O₅ (SO₂ → SO₃); Cu/ZnO/Al₂O₃ (CH₃OH); Fe/Co (Fischer–Tropsch); Ni (reforming, oil hydrogenation); Ag (ethylene oxide); CoMo/NiMo sulfides (HDS); Pt/Pd/Rh (exhaust); TiCl₄/MgCl₂ + AlEt₃ (Ziegler–Natta)
NH₃ synthesisrate-determining step: dissociative N₂ chemisorption
Mars–van Krevelenlattice oxygen oxidises substrate; O₂ reoxidises oxide

Last-Minute Traps

Where Next

Advertisement
Advertisement